Discounted set of Fenix HT18Rhunting flashlight , Fenix AER-05 cable switch and Fenix ALG-18 gun mount .
The Fenix HT18R rechargeable hunting flashlight is one of the tactical flashlights with the greatest range on offer. Its powerful reflector offers a range of up to 1,100 meters and a luminous flux of up to 2,800 lumens (ANSI). The light source is the high-performance LED SFT-70 from the Americ
...
watchdog_desc
Discounted set of Fenix HT18Rhunting flashlight , Fenix AER-05 cable switch and Fenix ALG-18 gun mount .
The Fenix HT18R rechargeable hunting flashlight is one of the tactical flashlights with the greatest range on offer. Its powerful reflector offers a range of up to 1,100 meters and a luminous flux of up to 2,800 lumens (ANSI). The light source is the high-performance LED SFT-70 from the American manufacturer Luminus. A single Li-ion battery type 21700 with a capacity of 5000 mAh is used for power supply (battery included). The Fenix HT18R LED flashlight has a total of six white light functions with up to 42 hours of illumination, including strobe and SOS flashing. There is a tactical dual switch on the rear of the flashlight allowing for both instant push activation and instant strobe activation. Additionally, a red and green filter is included. Long gun mounts and the Fenix AER-05 cable switch are compatible with the flashlight. The Fenix HT18R is the ultimate light tool for professionals, hunters and all users requiring the longest range possible.
All flashlight parameters (lumen output, battery life, waterproof, range and shockproof) are measured in accordance with ANSI/NEMA FL 1-2009.
Press the main tactical button on the end of the flashlight to turn on/off, hold the button for instant activation. Press the secondary toggle button to switch between power modes at any time during operation. To switch to flash mode with the flashlight on, hold the toggle button, press the button again to switch to SOS. To switch the luminaire directly into strobe mode, press and hold the toggle button.
Memory for last set mode - the luminaire has a memory and will always switch on in the last set mode, except strobe and SOS.
Battery Replacement - unscrew the end cap of the flashlight and insert the battery with the plus terminal facing in. Then tighten the end cap fully again.
Charging - remove the dust cap and plug the USB-C charging cable into the charging port of the flashlight. During charging, the indicator opposite the charging connector glows red. When fully charged, it will turn green. When charging is complete, reseal the dust cap. Normal charging time is approximately 3.5 hours for a fully discharged flashlight. The flashlight cannot be used while charging.
Indication of battery charge status - each time the lamp is switched on, the indication LED opposite the charging connector is activated for three seconds. If the indicator LED is green, the battery is more than 85% charged. Green flashing indicates 50-85% capacity. If it glows red, it is 25-50% charged. Red flashing indicates less than 25% battery capacity remaining.
Intelligent overheat protection - if the temperature of the lamp exceeds 65°C (65°F), the power is automatically reduced. As soon as the temperature drops below 65°C, the highest power can be used again.
Low battery warning - if the voltage drops below the set level the luminaire will reduce the brightness to a lower level until it reaches an output of 30 lumens. When the lowest output is reached, the battery charge indicator will flash red to remind you to recharge or replace the battery.